Balance props right on a Tarantula X6

guess i never linked these here... it';s an older video so not the highest quality but you get the ideas..

Balance props on the quad..

Balance on a home made balancer...

build a stand yourself...

Simple Light wire covers

Simple, fast, removable, super light wire covers for the arms of the FrankenSpider...

Tarantula X6 Board v2 wiring..

here are some images of the stock wiring layout for the tarantula X6 board version 2 wiring as it comes from the factory..

Beginner advice for tarantula X6

Just a list of simple things to do when you first get your tarantula X6 (or really, just about any basic brushed motor quadcopter could use this as general advise)

Before 1st flight -

1 - Break in the motors! run the thing at the lowest speed you can for about 3 minutes.. If one motor isn't running or is slower than others, you pick it up and tilt it to each corner the lower corner will speed up a tad  ..

1st Flight-
 #1 - most important--- bind and SET GIRO's, - - Do this before every flight!! even when just changing batteries..Put TX(transmitter) in 100% rates (upper left shoulder button 2 times .. Transmitter will beep once for 40%, twice for 60% and three times for 100%) once in 100% rates make sure quad is sitting level as possible.. pull both sticks down and to the left bottom corner ... hold.. it'll take a bit but the quad will rapid blink.. keep holding till it's done.. giros are set and the thing should fly normally and self level/hover reasonably-- it's not GPS so there will be air flow drift...


Mark Billingham - The x6 can be very fast.if in headless mode try not to let the x6 fly behind you as naturally you will turn round to follow it away from your base point making the controls reverse even flying in headless

Mark Billingham If its your first flight stay low and fly into the wind

Unlike · Reply · 1 · December 27, 2015 at 1:44pm

Thom Lamourine What Mark just said X2!!! low and slow till you're used to it.

Like · Reply · 1 · December 27, 2015 at 1:48pm

Steve Huebner When you beat it up then build a franken spider!!

Unlike · Reply · 1 · December 29, 2015 at 9:00am

Jonas Moreira https://www.youtube.com/watch?v=F8-0fLbSdmY

Trim Adjustments Tarantula X6 YiZhan QuadCopter

YOUTUBE.COM

Like · Reply · Remove Preview · December 30, 2015 at 5:27pm

Thom Lamourine That's actually "setting the giros' not trimming.. but it's good  wink emoticon Trim adjustments are the tiny black buttons on the side of the sticks  smile emoticon

Like · Reply · December 30, 2015 at 5:38pm · Edited

Write a reply...

Bill Markey Always, with any quad basics must be followed.

Unlike · Reply · 1 · December 31, 2015 at 8:30pm

Thom Lamourine As Bill Markey stated, basics or Common sense must be followed! PLEASE DON'T FLY OVER CROWDS OR MOVING TRAFFIC!! as well as the know airport, military installations, or any other obvious threat sensitive property! These things are far from being "rel...See More

Like · Reply · 1 · January 1 at 10:38am · Edited

Thom Lamourine Remember you are flying in a 3D space.. 300 meters along the ground is NOT 300 meters fling space.. as you go up, you loose distance out you can go and keep the quad in reception of your TX.